Configuring Igmp Snooping Parameters - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Cli software configuration guide
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

IGMP Forwarding

Configuring IGMP Snooping Parameters

To manage the operation of the IGMP snooping process, you can configure the optional IGMP snooping
parameters described in the following table.
Table 19: IGMP Snooping Parameters
Parameter
IGMP snooping
Explicit tracking
Fast leave
Last member query interval
Snooping querier
Report suppression
Multicast router
Static group
You can disable IGMP snooping either globally or for a specific VLAN.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
218
Configuring IGMP Snooping Parameters
Description
Enables IGMP snooping on a per-VLAN basis. The
default is enabled.
If the global setting is disabled, then all
Note
VLANs are treated as disabled, whether they
are enabled or not.
Tracks IGMPv3 membership reports from individual
hosts for each port on a per-VLAN basis. The default
is enabled.
Enables the software to remove the group state when
it receives an IGMP Leave report without sending an
IGMP query message. This parameter is used for
IGMPv2 hosts when no more than one host is present
on each VLAN port. The default is disabled.
Sets the interval that the software waits after sending
an IGMP query to verify that no hosts that want to
receive a particular multicast group remain on a
network segment. If no hosts respond before the last
member query interval expires, the software removes
the group from the associated VLAN port. Values
range from 1 to 25 seconds. The default is 1 second.
Configures a snooping querier on an interface when
there is no multicast router in the VLAN to generate
queries. The default is disabled.
Limits the membership report traffic sent to
multicast-capable routers. When you disable report
suppression, all IGMP reports are sent as is to
multicast-capable routers. The default is enabled.
Configures a static connection to a multicast router.
The interface to the router must be in the selected
VLAN.
Configures an interface belonging to a VLAN as a
static member of a multicast group.
OL-16597-01

Advertisement

Table of Contents
loading

Table of Contents