Configuring The Radius Dead-Time Interval - Cisco Nexus 9000 Series Configuration Manual

Configuring the RADIUS Dead-Time Interval

Command or Action
switch# show radius-server
Step 6 (Optional) copy running-config startup-config
Example:
switch# copy running-config startup-config
Related Topics
Configuring the RADIUS Dead-Time Interval
You can configure the dead-time interval for all RADIUS servers. The dead-time interval specifies the time
that the Cisco NX-OS device waits after declaring a RADIUS server is dead, before sending out a test packet
to determine if the server is now alive. The default value is 0 minutes.
Note When the dead-time interval is 0 minutes, RADIUS servers are not marked as dead even if they are not
responding. You can configure the dead-time interval for a RADIUS server group.
SUMMARY STEPS
1. configure terminal
2. radius-server deadtime minutes
3. (Optional) show radius {pending | pending-diff}
4. (Optional) radius commit
5. exit
6. (Optional) show radius-server
7. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2 radius-server deadtime minutes
Example:
switch(config)# radius-server deadtime 5
Step 3
(Optional) show radius {pending | pending-diff}
Example:
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
60
Configuring RADIUS Server
Configuring Global Periodic RADIUS Server
Purpose
Copies the running configuration to the startup
configuration.
Hosts, on page 44
Monitoring, on page 57
Purpose
Enters global configuration mode.
Configures the dead-time interval. The default value is 0
minutes. The range is from 1 to 1440 minutes.
Displays the RADIUS configuration pending for
distribution.
Configuring RADIUS