Creating A Session; Configuring Session Manager; Configuring Acls In A Session - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring Session Manager

• You can configure a maximum of 20,000 commands across all sessions.
Configuring Session Manager

Creating a Session

You can create up to 32 configuration sessions. To create a configuration session, perform this task:
Procedure
Step 1
Step 2
Step 3

Configuring ACLs in a Session

You can configure ACLs within a configuration session. To configure ACLs within a configuration session,
perform this task:
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
326
Command or Action
switch# configure session name
switch(config-s)# show configuration
session [name]
switch(config-s)# save location
Command or Action
switch# configure session name
switch(config-s)# ip access-list name
switch(config-s-acl)# permit protocol source
destination
switch(config-s-acl)# interface interface-type
number
switch(config-s-if)# ip port access-group
name in
switch# show configuration session [name]
Configuring Session Manager
Purpose
Creates a configuration session and enters session
configuration mode. The name can be any
alphanumeric string.
(Optional)
Displays the contents of the session.
(Optional)
Saves the session to a file. The location can be in
bootflash or volatile.
Purpose
Creates a configuration session and enters
session configuration mode. The name can be
any alphanumeric string.
Creates an ACL.
(Optional)
Adds a permit statement to the ACL.
Enters interface configuration mode.
Adds a port access group to the interface.
(Optional)
Displays the contents of the session.
OL-16597-01