Removing A Sas Or Sata Hot-Swap Hard Disk Drive; Installing Or Removing A Slimline Optical Drive; Installing A Slimline Optical Drive - Intel SR1695WB Service Manual

Removing a SAS or SATA Hot-swap Hard Disk Drive

1. Press in on the green latch at the front of the hard drive carrier. and pull out on the
black lever to slide the carrier from the server system.
2. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier and store the drive in an anti-static bag.
3. With the black lever in the fully open position, slide the drive carrier into the server
system. The green latch must be to the right. Do not push on the black lever until
the lever begins to close by itself.
Note: All hard drive carriers must be installed in the server system and populated
4. When the black lever begins to close by itself, push on it to lock the drive carrier
into place.

Installing or Removing a Slimline Optical Drive

Caution: Slimline optical drives are NOT hot-swappable. Before removing or replacing the drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
To maintain proper system cooling, if you do not install a device at this location, you must
install the provided filler blank.

Installing a Slimline Optical Drive

1. Remove the slimline drive bay filler blank, if installed.
38
either with a drive or without a drive to maintain system thermals.
®
Intel Server System SR1695WB Service Guide