Table of Contents
Advertisement
3. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive
from the carrier and store the drive in an anti-static bag.
4. Do one of the following:
a. To install the replacement drive, see
b. If you are not installing a drive, place the plastic retention device into the drive
Note: To maintain proper system cooling, all hard drive carriers must be installed in the server
system and populated with either a drive or a drive blank.
5. With the black lever held in the fully open position, slide the drive carrier into the
server system and push all the way until it clicks.
6. Close the lever to lock the drive assembly into place.
Installing or Removing a Slimline Optical Drive or
Internal USB Floppy (Intel
only)
Cautions: The slimline optical drive is NOT hot-swappable. Before removing or replacing the drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
To maintain proper system cooling, a filler blank must be installed if you do not install a
device at this location.
Note: The Intel
place of the slimline SATA optical device.
®
Intel
Server System SR2600UR/SR2625UR Service Guide
Disk Drive" on page
71.
carrier and secure the device by inserting the four screws you removed from the
hard drive into the screw locations on the carrier.
®
Server System SR2600UR also supports the installation of a USB floppy in
"Installing a SAS or SATA Hot-swap Hard
®
Server System SR2600UR
77
Advertisement
Table of Contents
