Removing A Pentium Ii Processor; Installing The Memory Module - Intel MB440LX System Installation Manual

Removing a Pentium II Processor

See Figure 4-7.
1. Observe the warnings and cautions on page 3, "Safety Guidelines."
2. Remove the left side cover (page 80).
3. Squeeze the locking tabs and pull the module free from the connector.
4. Store the module in an antistatic protective wrapper, or place it
processor-side up on a nonconductive, static-free surface.

Installing the Memory Module

See Figure 4-8.
1. Observe the warnings and cautions on page 3, "Safety Guidelines."
2. Remove the left side cover (page 80).
3. Remove the rail.
4. Being careful not to touch the components or gold edge connectors on
the memory module, remove it from its protective wrapper and place it
socket-side up on a nonconductive, static-free surface.
5. Record the module serial number in your equipment log.
6. Hold the module by its top edge or upper corners, and firmly press it
into the connector (Figure 4-8) on the system board.
7. Install the rail.
92
Chapter 4 Working Inside Your System