3. Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two
rotations and stop (see letter "C"). (Do not fully tighten.)
4. Proceed to screw 2 and engage screw threads by giving it two rotations and stop (see letter "D").
Similarly, engage screws 3 and 4.
5. Repeat steps C and D by giving each screw two rotations each time until each screw is lightly
tightened up to a maximum of 8 inch-lbs torque (see letter "E").
Removing the Processor
1. Remove the processor heatsink, see Figure 26.
2. Open the socket lever, see Figure 27.
3. Open the load plate, see Figure 28.
4. Remove the processor.
Installing and Removing Memory
Installing Memory
1. Locate the DIMM sockets. Make sure the clips at either end of the DIMM socket(s) are pushed
outward to the open position (see letter "A").
®®
Intel
Server System R1000GZ/GL Service Guide
Figure 33. Installing Processor Heatsink
Hardware Installations and Upgrades
23
Need help?
Do you have a question about the Server System R1000GZ and is the answer not in the manual?