Table 42: Show Policy-List Output Fields - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Policy Management Configuration Guide
Table 42 on page 208 lists the show policy-list command output fields.
Meaning

Table 42: show policy-list Output Fields

208
Monitoring Policy Lists
Referenced by profile(s):
No profile references
Field Name
Policy
Administrative state
Reference count
Atm cell mode
Referenced by interfaces
Referenced by profiles
Referenced by merge policies
Referenced by component policies
Classifier control list
Statistics
Parent group
Rule types are:
filter
exception http-redirect
forward
Field Description
Name of the policy list.
For SNMP use; state is enabled when the policy
list is created. Users modifying the policy list
commands via telnet see the state as disabled.
Modifications of a policy are not applied to an
interface until the administrative state is first
disabled and then reenabled.
Number of attachments to interfaces or profiles.
An asterisk enclosed in parenthesis (*), if
displayed, denotes that the policy contains
inactive references to interfaces. The absence
of an asterisk denotes that all the attachments
of this policy to the specified number of
interfaces are active.
State of mode for ATM cell tax used in rate
calculations.
List of interfaces to which policy is attached and
is active; indicates whether the attachment is at
input or output of interface.
List of profiles to which policy is attached;
indicates whether the attachment is at input,
secondary-input, or output of interface created
by the profile.
List of merged policies.
List of component policies.
Name of the classifier control list containing
policy rules and the precedence assigned to the
classifier control list.
Enabled, disabled
Name of the parent group.
Filter policy action
HTTP redirect policy action
Forward policy action