Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 145

Referenced by profiles:
None
Referenced by merge policies:
None
IP Policy mpl_5
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.2 output policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
Detach p3 from atm 5/0.1.
17.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p3
host1(config-subif)#exit
Detach p1 from atm 5/0.2. Merge policy mpl_5 is detached and deleted and only
18.
p2 is now attached.
host1(config)#interface atm 5/0.2
host1(config-subif)#no ip policy output p1
host1(config-subif)#exit
Detach p2 from atm 5/0.2.
19.
host1(config)#interface atm 5/0.2
host1(config-subif)#no ip policy output p2
host1(config-subif)#exit
Display policies to verify that no merge policies exist and that all other policies
20.
have a 0 reference count because they are not attached anywhere.
host1#show policy-list
1
Policy Table
------ -----
Merging Policies Configuration
Chapter 6: Merging Policies
119