Table 43: Show Policy-Parameter Output Fields - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Policy Management Configuration Guide
Policy Parameter hierGroup2
To display list information:
host1(config)#show policy-parameter
Policy Parameter refRlpRate
Policy Parameter otherRate
Table 43 on page 210 lists the show policy-parameter command output fields.
Meaning

Table 43: show policy-parameter Output Fields

210
Monitoring Policy List Parameters
policy2
policy3
Type: hierarchical
Reference count: 3
Aggregation node: 3
Referenced by interfaces: 1 references
IP ATM5/0.2: atm-vp 1
Referenced by policies: 2 references
policy1
Referenced by parent groups: 1 references
extPg1
Type: reference-rate
Rate: 100000
Reference count: 7
Referenced by interfaces: 2 references
IP interface ATM5/0.1: 1000000
IP interface ATM5/0.2: 200000
Referenced by rate-limit profiles: 5 references
rlpData
rlpVoice
rlpVideo
reference-rate: 65536
Reference count: 3
Referenced by interfaces: 1 references
IP interface ATM5/0.2: 100000
Referenced by rate-limit profiles: 2 references
rlpOther
Field Name
Type
Reference count
Aggregation node
Referenced by interfaces
Referenced by profiles
Referenced by policies
Referenced by parent groups
Policy Parameter Table
------ --------- -----
Field Description
Type of parameter, such as hierarchical.
Number of references in policy, interface, and
external parent group profiles.
Aggregation node value.
List of interfaces where parameter is referenced.
List of profiles where parameter is referenced
List of policies where parameter is referenced.
List of external parent groups where parameter
is referenced.