Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 46

JUNOSe 11.1.x Policy Management Configuration Guide
20
Creating Policy Lists for ATM
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
ATM policy input polUbr
Statistics are disabled
1 interface(s) found
host1#show atm subinterface atm 0/0.101
Interface ATM-Prot VCD VPI VCI
----------- -------- --- --- --- ------- ----- ---- ------ ---------
ATM 0/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
ATM policy input polCbr
classifier-group *
3096 packets, 377678 bytes
traffic-class best-effort
: static
: none
: none
: none
: none
: none assigned
: none assigned
: none assigned
: none assigned
0
0
0
0
0
0
0
0
Circuit
Type Encap MTU
0 101 PVC SNAP 9180 up
: static
: none
: none
: none
: none
: none assigned
: none assigned
: none assigned
: none assigned
0
0
0
0
0
0
0
0
Interface
Status Type
Static