Creating Rate-Limit Profiles; Rate Limits For Interfaces Overview - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

Chapter 5

Creating Rate-Limit Profiles

This chapter provides information for configuring rate-limit policy management on
E Series routers. For information on monitoring rate-limit profiles, see "Monitoring
Rate-Limit Profiles" on page 211
This chapter discusses the following topics:
Rate Limits for Interfaces Overview on page 62
Hierarchical Rate Limits Overview on page 63
Percent-Based Rates for Rate-Limit Profiles Overview on page 73
Policy Parameter Quick Configuration on page 77
Creating Rate-Limit Profiles on page 77
One-Rate Rate-Limit Profiles Overview on page 82
Creating a One-Rate Rate-Limit Profile on page 83
Configuring a TCP-Friendly One-Rate Rate-Limit Profile on page 84
Two-Rate Rate-Limits Overview on page 86
Creating a Two-Rate Rate-Limit Profile on page 88
Setting the Committed Action for a Rate-Limit Profile on page 89
Setting the Committed Burst for a Rate-Limit Profile on page 90
Setting the Committed Rate for a Rate-Limit Profile on page 91
Setting the Conformed Action for a Rate-Limit Profile on page 91
Setting the Exceeded Action for a Rate-Limit Profile on page 91
Setting the Excess Burst for a Rate-Limit Profile on page 92
Setting the Mask Value for MPLS Rate-Limit Profiles on page 92
Setting the Mask Value for IP and IPv6 Rate-Limit Profiles on page 92
Setting the Peak Burst for Two-Rate Rate-Limit Profiles on page 93
Setting the Peak Rate for Rate-Limit Profiles on page 93
Setting a One-Rate Rate-Limit Profile on page 94
Setting a Two-Rate Rate-Limit-Profile on page 95
Bandwidth Management Overview on page 97
Rate-Limiting Traffic Flows on page 100
61