Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 220

JUNOSe 11.1.x Policy Management Configuration Guide
Table 38 on page 195 lists the show ip interfaces command output fields.
Meaning
194
Monitoring the Policy Configuration of IP Interfaces
Network Protocols: IP
Internet address is 10.12.1.1/255.255.255.0
Broadcast address is 255.255.255.255
Operational MTU = 0 Administrative MTU = 0
Operational speed = 100000000
Discontinuity Time = 0
Router advertisement = disabled
Proxy Arp = disabled
ARP spoof checking = enabled
Network Address Translation is disabled
TCP MSS Adjustment = disabled
Administrative debounce-time = disabled
Operational debounce-time
Access routing = disabled
Multipath mode = hashed
Auto Configure = disabled
Auto Detect = disabled
Re-Authenticate Auto Detect = disabled
Inactivity Timer = disabled
Use Framed Routes = disabled
Warm-restart initial-sequence-preference: Operational = 0 Administrative = 0
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Routed Packets 0, Bytes 0
Out Scheduler Dropped Packets 0, Bytes 0
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
IP policy output testPol
classifier-group *
0 packets, 0 bytes
forward
Virtual-router: default
List:
interface ATM11/0.1, order 100, rule 2 (not supported in output
policy)
next-hop 1.1.1.1, order 100, rule 3 (active) (not supported in
output policy)
rate-limit-profile R2
committed rate: 0 bps, committed burst: 0 bytes (default)
peak rate: 0 bps, peak burst: 0 bytes (default)
committed: 0 packets, 0 bytes, action: transmit conditional
conformed: 0 packets, 0 bytes, action: transmit conditional
exceeded: 0 packets, 0 bytes, action: drop
log
classifier-group video entry 1
0 packets, 0 bytes
filter
Administrative speed = 0
= disabled