Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 144

JUNOSe 11.1.x Policy Management Configuration Guide
16.
118
Merging Policies Configuration
host1(config-subif)#exit
Display policies to verify that p3 is attached to atm 5/0.1 and mpl_8 is removed.
host1#show policy-list
IP Policy p1
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy p2
Administrative state: enable
Reference count:
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 20.1.1.1, order 100, rule 3 (active)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy p3
Administrative state: enable
Reference count:
Classifier control list: C1, precedence 80
color yellow
Classifier control list: C4, precedence 900
color red
Referenced by interfaces:
ATM5/0.1 input policy, statistics disabled, virtual-router default
Policy Table
------ -----
1
1
1