Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 71

statistics for the classifier group referencing clOne and the default classifier group
are saved.
Original Policy Attachment
ip policy-list plOne
ip classifier-list clOne
Forward
ip classifier-list clTwo
Forward
ip classifier-list clThree
Forward
classifier-list *
Filter
You can use the merge keyword to enable merging of multiple policies to form a
single policy.
To assign the policy list named routeForXYZCorp with statistics enabled to the ingress
IP interface over an ATM subinterface:
To create an L2TP profile that applies the policy list routeForABCCorp to the egress
of an interface:
Related Topics
New Policy Attachment
ip policy-list plTwo
ip classifier-list clOne
Forward
ip classifier-list clFour
Forward
ip classifier-list clFive
Forward
classifier-list *
Filter
host1(config)#vlan policy input VlanPolicy33 statistics enabled preserve
host1(config)#ipv6 policy secondary-input my-policy
host1(config)#interface atm 12/0.1
host1(config)#ip policy input routeForXYZCorp statistics enabled
host1(config)#profile bostonProfile
host1(config)#l2tp policy output routeForABCCorp
atm policy
frame-relay policy
gre-tunnel policy
ip policy
ipv6 policy
l2tp policy
Chapter 4: Creating Classifier Groups and Policy Rules
Applying Policy Lists to Interfaces and Profiles Overview
Comment
-
statistics from plOne are saved
-
-
-
-
-
statistics from plOne are saved
-
45