Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 104

JUNOSe 11.1.x Policy Management Configuration Guide
3.
4.
5.
6.
7.
8.
78
Creating Rate-Limit Profiles
host1(config-rate-limit-profile)#peak-rate refRlpRate percentage 100
host1(config-rate-limit-profile)#peak-burst millisecond 150
host1(config-rate-limit-profile)#exit
Create rate-limit profile rlpVoice.
host1(config)#ip rate-limit-profile rlpVoice
host1(config-rate-limit-profile)#committed-rate 64000
host1(config-rate-limit-profile)#committed-burst 100000
host1(config-rate-limit-profile)#peak-rate refRlpRate percentage 100
host1(config-rate-limit-profile)#peak-burst millisecond 150
host1(config-rate-limit-profile)#exit
Create rate-limit profile rlpVideo.
host1(config)#ip rate-limit-profile rlpVideo
host1(config-rate-limit-profile)#committed-rate refRlpRate percentage 70
host1(config-rate-limit-profile)#committed-burst millisecond 100
host1(config-rate-limit-profile)#peak-rate refRlpRate percentage 100
host1(config-rate-limit-profile)#peak-burst millisecond 150
host1(config-rate-limit-profile)#exit
Create the policy.
host1(config)#ip policy-list P
host1(config-policy)#classifier-group data
host1(config-policy-classifier-group)#rate-limit-profile rlpData
host1(config-policy-classifier-group)#exit
host1(config-policy)#classifier-group voice
host1(config-policy-classifier-group)#rate-limit-profile rlpVoice
host1(config-policy-classifier-group)#exit
host1(config-policy)#classifier-group video
host1(config-policy-classifier-group)#rate-limit-profile rlpVideo
host1(config-policy-classifier-group)#exit
host1(config-policy)#exit
Attach IP Policy P at interface atm5/0.1.
host1(config)#interface atm 5/0.1
host1(config-if)#ip policy-parameter reference-rate refRlpRate 1000000
host1(config-if)#ip policy input P
Attach IP Policy P at interface atm5/0.2 with merge.
host1(config)#interface atm 5/0.2
host1(config-if)#ip policy input P stats enabled merge
Display the policy list.
host1#show policy-list
Policy Table
------ -----
IP Policy P
Administrative state: enable
Reference count:
Classifier control list: data, precedence 100
1