Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 143

Referenced by merge policies:
mpl_8
IP Policy mpl_5
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
ATM5/0.2 output policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p2
IP Policy mpl_8
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 80
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
next-hop 20.1.1.1, order 100, rule 3 (reachable)
color yellow
Classifier control list: C4, precedence 900
color red
Referenced by interfaces:
ATM5/0.1 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Component policies:
p1
p3
Detach p1 from atm 5/0.1. Merge policy mpl_8 is detached and deleted, and
15.
only p3 is attached to this interface.
host1(config)#interface atm 5/0.1
host1(config-subif)#no ip policy input p1
1
1
Merging Policies Configuration
Chapter 6: Merging Policies
117