Table 41: Show Parent-Group Output Fields; Monitoring Policy Lists - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Policy Management Configuration Guide
Table 41 on page 204 lists the show parent-group command output fields.
Meaning

Table 41: show parent-group Output Fields

Related Topics

Monitoring Policy Lists

Display information about policy lists.
Purpose
To display policy lists:
Action
host1#show policy-list
IPv6 Policy ipv6-pol8
default
default
IP Policy routeForABCCorp
204
Monitoring Policy Lists
Field Name
Reference count
Rate limit profile
Next parent group
Referenced by policies
Referenced by parent groups
show parent-group
Administrative state: enable
Reference count: 2
Classifier control list: *, precedence 100
forward
Referenced by interface(s):
GigabitEthernet1/0/2.1
GigabitEthernet1/0/2.1
Referenced by profile(s):
None
Referenced by merged policies:
None
Administrative state: enable
Reference count: 0
Field Description
Number of references within policies and other
external parent groups.
Name of hierarchical rate limit profile.
Name of the next parent group and parameter.
List of policies where this parent group is
referenced.
List of parent groups where the parent group is
referenced.
Policy Table
------ -----
input policy, statistics enabled, virtual-router
output policy, statistics enabled, virtual-router