Unsupported Features; E120 Router And E320 Router; Policy Management; Stateful Srp Switchover (High Availability) - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - RELEASE NOTES 2010-11-09 Release Note

JunosE 11.3.0 Release Notes

Unsupported Features

E120 Router and E320 Router

Policy Management

Stateful SRP Switchover (High Availability)

12

Unsupported Features

As part of this feature, the following SNMP MIB objects have been added to the
Juniper Networks Redundancy MIB to support the stateful line module switchover
functionality:
 juniLcRedundancyActiveSlot
 juniLcCardRedundancyStandbySlot
 juniLcRedundancyLastResetReason
 juniLcRedundancyActivationType
 juniLcRedundancyHaActiveTime
 juniLcRedundancySwitchoverTime
In addition, the ha event log category has been modified to record information when
the system transitions from one high availability state to another, when a stateful line
module switchover is performed.
The JunosE Release 11.3.x documentation set describes some features that are present
in the code but that have not yet been fully qualified by Juniper Networks. If you use any
of these features before they have been fully qualified, it is your responsibility to ensure
that the feature operates correctly in your targeted configuration.
The following features are present but unsupported in this release.
The ES2 10G LM and ES2 10G Uplink LM do not support layer 2 statistics for VLANs.

Subscriber Interfaces on the ES2 10G Uplink LM

You can configure dynamic subscriber interfaces and static subscriber interfaces on
the ES2 10G Uplink LM using the CLI. However, configuring subscriber interfaces on
the ES2 10G Uplink LM provides no benefit because access features such as
per-subscriber QoS are unavailable on the module.
External Parent Groups Unsupported on ES2 10G, ES2 10G Uplink, and ES2 10G ADV

LMs
External parent groups are not supported on the ES2 10G, ES2 10G Uplink, and ES2
10G ADV LMs. If you create a policy that references an external parent group on these
LMs, the system prevents you from attaching it to the LM interface and you receive an
error message.
Stateful SRP Switchover for Certain Applications

The stateful SRP switchover feature has not been qualified for the following
applications:
Remote Access

DHCP proxy client

L2TP dialout
Copyright © 2010, Juniper Networks, Inc.