Table of Contents
Advertisement
JUNOSe 11.1.x Policy Management Configuration Guide
9.
10.
112
Merging Policies Configuration
host1(config-subif)#ip policy output p1 statistics enable merge
host1(config-subif)#exit
Attach IP policy p2 at atm 5/0.2 as output. Merge policy mpl_5 is now attached.
host1(config)#interface atm 5/0.2
host1(config-subif)#ip policy output p2 merge
host1(config-subif)#exit
Display policies to verify that mpl_5 is created.
host1#show policy-list
IP Policy p1
Administrative state: enable
Reference count:
Classifier control list: C2, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 10.1.1.1, order 100, rule 2 (active)
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy p2
Administrative state: enable
Reference count:
Classifier control list: C3, precedence 10
filter
Classifier control list: C1, precedence 90
forward
Virtual-router: default
List:
next-hop 20.1.1.1, order 100, rule 3 (active)
Classifier control list: *, precedence 1000
forward
Referenced by interfaces:
None
Referenced by profiles:
None
Referenced by merge policies:
mpl_5
IP Policy mpl_5
Administrative state: enable
Reference count:
Policy Table
------ -----
1
1
2
Advertisement
Table of Contents
Need help?
Do you have a question about the POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X and is the answer not in the manual?
Questions and answers