Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual page 105

rate-limit-profile rlpData
Classifier control list: voice, precedence 100
rate-limit-profile rlpVoice
Classifier control list: video, precedence 100
rate-limit-profile rlpVideo
Referenced by interfaces:
ATM5/0.1 input policy, statistics disabled, virtual-router default
ATM5/0.2 input policy, statistics enabled, virtual-router default
Referenced by profiles:
None
Referenced by merge policies:
None
Display the rate-limit profiles.
9.
host1#show rate-limit-profile
Rate Limit Profile Table
---- ----- ------- -----
IP Rate-Limit-Profile: rlpData
Profile Type:
Reference count:
Committed rate:
Committed burst:
Peak rate:
Peak burst:
Mask:
Committed rate action:
Conformed rate action:
Exceeded rate action:
IP Rate-Limit-Profile: rlpVoice
Profile Type:
Reference count:
Committed rate:
Committed burst:
Peak rate:
Peak burst:
Mask:
Committed rate action:
Conformed rate action:
Exceeded rate action:
IP Rate-Limit-Profile: rlpVideo
Profile Type:
Reference count:
Committed rate:
Committed burst:
Peak rate:
Peak burst:
Mask:
Committed rate action:
Conformed rate action:
Exceeded rate action:
Display policy parameters. If a rate-limit profile uses this parameter twice then
10.
it increases the reference count by 2.
Chapter 5: Creating Rate-Limit Profiles
two-rate
1
refRlpRate % 10
100 milliseconds
refRlpRate % 100
150 milliseconds
255
transmit
transmit
drop
two-rate
1
64000
100000
refRlpRate % 100
150 milliseconds
255
transmit
transmit
drop
two-rate
1
refRlpRate % 70
100 milliseconds
refRlpRate % 100
150 milliseconds
255
transmit
transmit
drop
Creating Rate-Limit Profiles
79