Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
•
To control multicasts storms, use the port storm-control broadcast enable and port storm-
control broadcast rate commands.
Example
The following example enables counting broadcast and multicast packets on Ethernet port 2/e3.
Console(config)# interface ethernet 2/e3
Console(config-if)# port storm-control include-multicast
port storm-control broadcast enable
The port storm-control broadcast enable Interface Configuration (Ethernet) mode command
enables broadcast storm control. To disable broadcast storm control, use the no form of this
command.
Syntax
port storm-control broadcast enable
no port storm-control broadcast enable
Default Configuration
Broadcast storm control is disabled.
Command Modes
Interface Configuration (Ethernet) mode
User Guidelines
•
Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode
command, to set the maximum allowable broadcast rate.
•
Use the port storm-control include-multicast Interface Configuration (Ethernet) mode
command to count multicast packets and optionally unknown unicast packets in the storm
control calculation.
Example
The following example enables storm control on Ethernet port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# port storm-control broadcast enable
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
Ethernet Configuration Commands
169