Mdix - Dell PowerConnect 3424 Cli Reference Manual
Command line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 3424:
- Release notes (9 pages) ,
- User manual (402 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Default Configuration
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
•
Negotiation should be enabled for flow control auto.
Example
In the following example, flow control is enabled on port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# flowcontrol on
mdix
The mdix Interface Configuration (Ethernet) mode command enables cable crossover on a
given interface. To disable cable crossover, use the no form of this command.
Syntax
mdix {on | auto}
no mdix
•
on — Manual mdix
•
auto — Automatic mdi/mdix
Default Configuration
The default setting is on.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
•
Auto: All possibilities to connect a PC with cross or normal cables are supported and are
automatically detected.
•
On: It is possible to connect to a PC only with a normal cable and to connect to another
device only with a cross cable.
•
No: It is possible to connect to a PC only with a cross cable and to connect to another device
only with a normal cable.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
Ethernet Configuration Commands
157
- Quick Links:
- Introduction
- Ip Addressing
Hide quick links:
Advertisement
Table of Contents
