Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
•
Rules with Ethernet, VLAN and port-channel parameters are valid only if an IP address is
defined on the appropriate interface.
•
The system supports up to 128 management access rules.
Example
The following example denies all ports in the access list called mlist.
Console(config)# management access-list mlist
Console(config-macl)# deny
management access-class
The management access-class Global Configuration mode command restricts management
connections by defining the active management access list. To disable this restriction, use the
no form of this command.
Syntax
management access-class {console-only | name}
no management access-class
•
name — Specifies the name of the access list to be used. (Range: 1-32 characters)
•
console-only — Indicates that the device can be managed only from the console.
Default Configuration
If no access list is specified, an empty access list is used.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
228
Management ACL