switchport customer vlan
Use the switchport customer vlan interface configuration command set the port's VLAN when the
interface is in customer mode. Use the no form of this command to revert to default.
Syntax
switchport customer vlan vlan-id
no switchport customer vlan
vlan-id — VLAN ID of the customer
Default Configuration
No VLAN is configured
Command Mode
Interface configuration (Ethernet, port-channel)
User Guidelines
There are no user Guidelines for this command
Example
The following example sets the port's VLAN when the interface is in customer mode.
Console(config)# interface ethernet 1/e5
Console(config-if)# switchport customer vlan vlan-id
ip internal-usage-vlan
The ip internal-usage-vlan Interface Configuration mode command reserves a VLAN as the
internal usage VLAN of an interface. To return to the default configuration, use the no form of
this command.
Syntax
ip internal-usage-vlan vlan-id
no ip internal-usage-vlan
•
vlan-id — Specifies the ID of the internal usage VLAN.
Default Configuration
The software reserves an unused VLAN as the internal usage VLAN of an interface.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
415
VLAN Commands