Switchport General Pvid - Dell PowerConnect 3424 Cli Reference Manual

User Guidelines
• This command enables changing the egress rule (e.g., from tagged to untagged) without first
removing the VLAN from the list.
Example
The following example adds VLANs 2, 5, and 6 to the allowed list of Ethernet port 1/e16 .
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general allowed vlan add 2,5-6
tagged

switchport general pvid

The switchport general pvid Interface Configuration mode command configures the PVID
when the interface is in general mode. To return to the default configuration, use the no form of
this command.
Syntax
switchport general pvid vlan-id
no switchport general pvid
• vlan-id — Specifies the PVID (Port VLAN ID).
Default Configuration
If the default VLAN is enabled, PVID = 1. Otherwise, PVID=4095.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the PVID for Ethernet port 1/e16, when the interface is in
general mode.
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general pvid 234
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
412
VLAN Commands