Lldp Optional-Tlv; Lldp Management-Address - Dell PowerConnect 3424 Cli Reference Manual

Usage Guidelines
• It is recommended that the TxDelay would be less than 0.25 of the LLDP timer interval.
Examples
The following example specifies the delay between successive LLDP frame transmissions initiated
by value/status changes in the LLDP local systems MIB.
Console (config) # lldp tx-delay 7

lldp optional-tlv

To specify which optional TLVs from the basic set should be transmitted, use the lldp optional-tlv
command in interface configuration mode. To revert to the default setting, use the no form of this
command.
Syntax
lldp optional-tlv tlv1 [tlv2 ... tlv5]
no lldp optional-tlv
• tlv — Specifies TLV that should be included. Available optional TLVs are: port-desc, sys-
name, sys-desc and sys-cap . (Range 1-8192 seconds).
Default Configuration
No optional TLV is transmitted.
Command Modes
Interface configuration (Ethernet)
User Guidelines
There are no user guidelines for this command.
Example
The following example specifies which optional TLV (2)s from the basic set should be transmitted.
Console(config)# interface ethernet g5
Console(config-if)# lldp optional-tlv sys-name

lldp management-address

To specify the management address that would be advertised from an interface, use the lldp
management-address command in interface configuration mode. To stop advertising management
address information, use the no form of this command.
219
LLDP Commands