Sntp Broadcast Client Enable; Mdix; Port Storm-Control Broadcast Enable; Port Storm-Control Broadcast Rate - Dell PowerConnect 5324 Release Note

sntp broadcast client enable

Update the command as follows:
Field Current Guide
Dedscription To disable the SNTP anycast client, use
the no form of this command.

Mdix

Update the command as follows:
Field Current Guide
Syntax on—Manual mdix
Parameter

port storm-control broadcast enable

Update the command as follows:
Field Current Guide
Syntax port storm-control broadcast enable
Parameter
no port storm-control broadcast enable

port storm-control broadcast rate

Update the command as follows:
Field Current Guide
Syntax rate—Maximum kilobytes per second of
Parameter broadcast and multicast traffic on a port.
(Rate: 0 - 1488095
User The granularity is 1 - 64K packets. Note
Guidelines that if the rate is 0, broadcast packets are
not forwarded.
Example console(config-if)# port storm-control
broadcast rate 10
System Firmware Version 2.0.0.39
PowerConnect 5324 Release Notes
)
Subject to Change Without Notice
Change to:
To disable the anycast client, use the no form of
this command.
Change to:
on—Enable mdi/mdix
Change to:
port storm-control broadcast enable[ethernet
interface]
no port storm-control broadcast enable
♦
interface—A valid Ethernet port.
Change to:
♦
rate—Maximum kilobytes per second of
broadcast and multicast traffic on a port.
)
(Rate: 0 – 65535
Delete this guideline.
console(config)# port storm-control broadcast
rate 10
Page 15