Example
In the following example, automatic crossover is enabled on port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# mdix auto
back-pressure
The back-pressure Interface Configuration (Ethernet) mode command enables back pressure
on a given interface. To disable back pressure, use the no form of this command.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
•
Back pressure cannot be configured on trunks.
Example
In the following example back pressure is enabled on port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# back-pressure
clear counters
The clear counters User EXEC mode command clears statistics on an interface.
Syntax
clear counters [ethernet interface | port-channel port-channel-number]
•
interface — Valid Ethernet port. (Full syntax: unit/port)
•
port-channel-number — Valid port-channel number.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
158
Ethernet Configuration Commands