Duplex - Dell PowerConnect 3424 Cli Reference Manual
Command line interface (cli) guide (.htm)
Hide thumbs
Also See for PowerConnect 3424:
- Release notes (9 pages) ,
- User manual (402 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
duplex
The duplex Interface Configuration (Ethernet) mode command configures the full/half duplex
operation of a given Ethernet interface when not using auto-negotiation. To restore the default
configuration, use the no form of this command.
Syntax
duplex {half | full}
no duplex
•
half — Forces half-duplex operation
•
full — Forces full-duplex operation
Default Configuration
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
•
When configuring a particular duplex mode on the port operating at 10/100 Mbps, disable
the auto-negotiation on that port.
•
Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Example
The following example configures the duplex operation of Ethernet port 1/e5 to full duplex
operation.
Console(config)# interface ethernet 1/e5
Console(config-if)# duplex full
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LY
Ethernet Configuration Commands
155
- Quick Links:
- Introduction
- Ip Addressing
Hide quick links:
Advertisement
Table of Contents
