Lan Connection Test - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

PLEASE WAIT...
UNIT IS OK
The following GSM/ GPRS messages are reported:
Message
Unit is OK
GSM comm. loss
Pin code fail
GSM net. fail
SIM card fail
GSM not detected
No GPRS service
GPRS conn. fail
Srvr unavailable
IP not defined
APN not defined
SIM card locked
Denied by server

5.1.6 LAN Connection Test

The LAN Connection diagnostic procedure tests PowerLink Broadband Module communication to the IPMP and
reports the diagnostic result. In case of communication failure, detailed information of the failure is reported.
Note: If the PowerLink Broadband Module is not registered to the PowerMaster-10, the menu "
" will not be displayed.
CONNECT.TEST
1.
DIAGNOSTICS
2.
WL DEVICES
or
3.
LAN
4.
PLEASE WAIT...
UNIT IS OK
68
See the table below for a complete list of possible GSM/GPRS
messages.
∗ If there are no wireless devices enrolled in the PowerMaster-10
system, the PowerMaster-10 display reads "
** When the
before it is displayed, depending on the severity of the failure.
Pressing the
will take you to "
end of the procedure will take you to the "
Description
GSM / GPRS is functioning correctly.
The GSM/GPRS module does not communicate with the Panel
Missing or wrong PIN code.
(Only if SIM card PIN code is enabled.)
Unit failed with registration to local GSM network.
SIM not installed or SIM card failure.
GSM auto enroll failed to detect GSM/GPRS module.
The SIM card does not have the GPRS service enabled.
Local GPRS network is not available or, wrong setting to GPRS APN, user and/or
password.
IPMP Receiver cannot be reached – Check the Server IP
Server IP #1 and #2 are not configured.
APN is not configured.
After entering a wrong PIN code 3 consecutive times the SIM is locked. To unlock it
enter a PUK number. The PUK number cannot be entered by the PowerMaster-10.
The IPMP denies the connection request. Check that the Panel is registered to the IPMP
Receiver.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
*
**
button is pressed the test result takes up to 4 min.
or buttons at any stage in the procedure
" or pressing the
<OK> TO EXIT
".
NO DEVICES
button at the
" menu.
LAN
D-302756
LAN