Event Reporting Configuration; General; Setup Report Communicators - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

4.
disable on fail
or
5.
6.
27:SIREN ON LINE

4.7 Event Reporting Configuration

4.7.1 General

The PowerMaster-10 system uses an IP platform that supports GSM and GPRS cellular communication and
broadband to forward all events received at the control panel to the monitoring station.

4.7.2 Setup Report Communicators

4.7.2.1 Configuring PSTN / GSM Communicators
1.
DEFINE COMM.
2.
1:PSTN/GSM
3.
AREA CODE
TEL. AREA CODE
4.
5.
AREA CODE
6.
LINE PREFIX
LINE PREFIX
7.
8.
LINE PREFIX
9.
DIAL METHOD
10.
Pulse
11.
or
12.
D-302756
Select between "disable on fail" and "enable on fail".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Enter the system tel. area code (up to 4 digits).
Enter the number that is used as a prefix to access an outside telephone
line (if exists).
Here you determine the dialing method used by the automatic dialer built
into the PowerMaster-10 control panel.
Select between "Pulse" and "tone (dtmf)".
or button to program any other
" or press the button to take you to "
<OK>
27