Visonic POWERMASTER-10 - INSTALLER GUIDE Manual page 37

PSTN RPRT RETRY
2.
4 attempts
3. or
4.
PSTN RPRT RETRY
5.
GSM RPRT RETRY
6.
4 attempts
7.
or
8.
GSM RPRT RETRY
9.
LAN RPRT RETRY
10.
4 attempts
11.
or
12.
LAN RPRT RETRY
4.7.3.7 Configuring the Auto Test Report
Continue below from the previous section or repeat steps 1 to 4 of section 4.7.3.1 before continuing with the
following instructions:
REPORT EVENTS
or
1.
AUTO TEST TIME
2.
test time 12:00P
3.
AUTO TEST TIME
4.
36
Here you determine the number of times the communicator will dial the
Monitoring Station's number via PSTN.
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
Here you determine the number of times the communicator will try to
report via a cellular group (GPRS, GSM and SMS) to the Monitoring
Station.
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
Here you determine the number of times the communicator will try to
report via the PowerLink Broadband Module communication to the
Monitoring Station.
Select between "2 attempts", "4 attempts", "8 attempts", "12
attempts" and "16 attempts".
You can now press the
" menu, or press the
TIME
Here you determine the time at which the telephone line will be tested
and reported to the Monitoring Station.
Enter the auto test time.
button to take you to the "
button to take you to "
AUTO TEST
".
<OK> TO EXIT
D-302756