Visonic POWERMASTER-10 - INSTALLER GUIDE Manual page 42

3 attempts
27. or
28.
Redial attempts
29.
Tel. acknowledge
30.
single ack
31. or
32.
Tel. acknowledge
33.
VOICE REPORT
D. To Configure Reports to User by SMS
VOICE REPORT
34.
SMS REPORT TEL#
35.
1st SMS tel#
36.
37.
1st SMS TEL. NO.
38.
1st SMS tel#
39.
2nd SMS tel#
40.
41.
2nd SMS TEL. NO.
D-302756
Select between "1 attempt", "2 attempts", "3 attempts" and "4
attempts".
Attention! A maximum of 2 dialing attempts is permitted by the
Australian Telecommunication Authority.
Here you determine whether the system will use the single acknowledge
or the all acknowledge mode when reporting to private telephones.
Note: In the single acknowledge mode, receiving an acknowledge signal
from a single telephone is sufficient to consider the current event closed
and call off the communication session. The remaining telephones serve
for backup purposes only. In the all acknowledge mode, an acknowledge
signal must be received from each telephone before the current event is
considered reported.
Select between "single ack" and "all ack".
You can now press the
" menu (see the next section), or press the
TEL#
you to " ".
<OK> TO EXIT
Enter the first SMS phone number (including area code, 16 digits max.)
to which pre-selected event types will be reported.
Enter the second SMS phone number (including area code, 16 digits
max.) to which pre-selected event types will be reported.
button to take you to the "
SMS REPORT
button to take
41