9.
ENROLL NOW or
ENTR ID:100-xxxx
DEVICE ENROLLED
Z01: Contact Sens
ID No. 100-2332
4.5.7 Defining Defaults
Attention! When changing the default parameters of one device in Define Defaults, all new devices of the same
device type that are enrolled in the PowerMaster-10 system will have the same defaults. Devices that were
already enrolled in the PowerMaster-10 system before the procedure was performed will not be affected by the
new default settings.
To Define Device Defaults
1.
ZONES/DEVICES
2.
ADD NEW DEVICES
3.
or
DEFINE DEFAULTS
4.
CONTACT SENSORS
5.
or
KEYFOBS
6.
24
Enroll the new device, or, enter the last 4 digits of the ID number of the
new device.*
The PowerMaster-10 display will read the result.**
*
If the device was previously enrolled in the system, the PowerMaster-
10 display reads "
name of the device alternating with the ID number of the device.
If the device ID number is invalid the PowerMaster-10 display reads
"
".
WRONG ID No
If the new device type is different from the existing device to be
replaced, the PowerMaster-10 display reads "
** If the device was enrolled manually, by entering the ID number, the
PowerMaster-10 display reads "
At the end of the procedure you can press the
the same procedure for a different device of the same type, or you can
press the
button to select a different device type to be replaced,
or you can press the
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select the desired device whose defaults you wish to define. Select
between "CONTACT SENSORS", "MOTION SENSORS", "SMOKE SENSORS",
"KEYFOBS" and "SIRENS", for example, "KEYFOBS".
" and then switches to the
ALREADY ENROLLED
ID ACCEPTED
button to take you to "
".
WRONG DEV.TYPE
".
button and perform
".
<OK> TO EXIT
D-302756
Need help?
Do you have a question about the POWERMASTER-10 - INSTALLER GUIDE and is the answer not in the manual?