Configuring The Period Of Strobe Light Activation; Enabling Siren Activation Upon Telephone Line Failure - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

4.
piezo siren ON
or
5.
6.
24:PIEZO SIREN

4.6.3 Configuring the Period of Strobe Light Activation

Here you can define the period of strobe light activation when the siren is in alarm state.
Options: 5 minutes, 10 minutes, 20 minutes (default), 40 minutes and 60 minutes.
To Configure the Period of Strobe Light Activation
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
40:STROBE TIME
4.
20 minutes
or
5.
6.
40:STROBE TIME

4.6.4 Enabling Siren Activation upon Telephone Line Failure

Here you determine whether the siren will be activated or not when the telephone line fails during system armed
state. Available options are: enable on fail, disable on fail (default).
To Enable Siren Activation upon Telephone Line Failure
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
27:SIREN ON LINE
26
Select between "piezo siren ON" and "piezo siren OFF".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "5 minutes", "10 minutes", "20 minutes", "40
minutes" and "60 minutes".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
or button to program any other
" or press the
or button to program any other
" or press the
button to take you to "
<OK>
button to take you to "
<OK>
D-302756