Configuring The Screen Saver Options - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

2.
01:ENTRY DELAY 1
or
3.
29:DISARM OPTION
4.
any time
or
5.
6.
29:DISARM OPTION

4.10.5 Configuring the Screen Saver Options

Here you can determine that if no key is pressed during more than 30 seconds the display will read
"PowerMaster-10" (to prevent a possible intruder of knowing the system status). You can determine that normal
display will return after pressing the
pressing any key (Refresh by Key).
If Refresh by Key is selected, the first pressing of any key (except Fire and Emergency) will cause normal display
return and the second press will perform the key function. Regarding the Fire and Emergency keys, the first key
press will cause normal display return and also will perform the Fire/Emergency function.
Options: scrn saver OFF (default), refresh by code, refresh by key.
Note: To comply with EN requirements, "refresh by code" must be selected.
To Configure the Screen Saver Option
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
32:SCREEN SAVER
4.
scrn saver OFF
or
5.
6.
32:SCREEN SAVER
D-302756
Select between "any time", "on entry wrless", "entry + away kp"
and "on entry all".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
button followed by entering user code (Refresh by Code) or after
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "scrn saver OFF", "refresh by Code", and "refresh
by Key".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
or button to program any other
" or press the button to take you to "
or button to program any other
" or press the button to take you to "
<OK>
<OK>
55