Displaying Signal Strength Indication Of Rf Devices; Gprs Communication Test - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

5.1.4 Displaying Signal Strength Indication of RF Devices

1.
DIAGNOSTICS
2.
WL DEVICES
3.
TEST ALL DEVICES
or
4.
SHOW RF PROBLEMS
5.
Z01: 24hr: GOOD
Z01: NOW: NOT TST
6.
K01: 24hr: NONE
K01: NOW: NONE

5.1.5 GPRS Communication Test

The GPRS Communication diagnostic procedure tests GSM/GPRS communication and reports the diagnostic
result. In case of communication failure, detailed information of the failure is reported.
1.
DIAGNOSTICS
2.
WL DEVICES
3.
GSM/GPRS
4.
D-302756
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
The PowerMaster-10 display switches between the average signal
strength indication for the last 24 hours and the current signal strength
indications of the first device type.∗
Press the button to view the signal strength indications for the
next RF device type.*
The signal strength indications are as follows: "
" " (the device operates in 1-way mode, or, the "NOW"
1-WAY
communication test failed); "
(results are shown without any performed test); "
enrolled – not networked); "
(result of the last 24Hrs without statistics).
∗
Pressing the
to which the signal strength indications refer.
Pressing the
will take you to "
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
*
**
." (no communication); "
NO COM
" (keyfob 24Hr result); or "
NONE
button will display the number and type of device
or buttons at any stage in the procedure
".
"; "; "
STRONG GOOD POOR
NOT TST
" (device is pre-
NOT NET
EARLY
";
"
"
67