Configuring Exit Delay Duration; Enabling Quick Arm - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

3.
entry dly1 30s
or
4.
5.
09:EXIT MODE

4.9.3 Configuring Exit Delay Duration

An exit delay allows the user to arm the system and leave the protected site via specific routes and doors
without causing an alarm. Slow-rate warning beeps start sounding once the arming command has been given,
until the last 10 seconds of the delay, during which the beeping rate increases. Location No. 3 allows
programming of the exit delay length. Available options are: 30s, 60s (default), 90s, 120s, 3m, and 4m
Note: To comply with CP-01 requirements, "30s" option is not available
Note: To comply with UL requirements, the exit delay must not exceed 120 sec
To Configure the Exit Delay Duration
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
03:EXIT DELAY
4.
exit delay 60s
or
5.
6.
03:EXIT DELAY

4.9.4 Enabling Quick Arm

Here you determine whether the user will be allowed to perform quick arming or not. Once quick arming is
permitted, the control panel does not request a user code before it arms the system.
The two options are: quick arm ON (default in USA) and quick arm OFF (default).
50
Select between "entry dly1 00s", "entry dly1 15s", "entry dly1
30s", "entry dly1 45s", "entry dly1 60s", "entry dly1 3m" and
"entry dly1 4m".**
* Press the
** In the "
02:ENTRY DELAY 2
" ...".
entry dly2
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "exit delay 30s", "exit delay 60s", "exit delay
90s", "exit delay 120s", "exit delay 3m"and "exit delay 4m".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
button for "
02:ENTRY DELAY 2
" menu, the PowerMaster-10 display will read
or
" or press the
.
.
or
" or press the
".
button to program any other
button to take you to "
.
button to program any other
button to take you to "
D-302756
<OK>
<OK>