Visonic POWERMASTER-10 - INSTALLER GUIDE Manual page 62

B. To Configure PGM Lighting Devices in Alarm Conditions and To Set Daytime Limits of Lighting Devices
1.
DEFINE OUTPUTS
2.
DEFINE PGM
3.
PGM: GENERAL DEF
4.
FLASH ON ALARM
5.
no flash
or
6.
7.
FLASH ON ALARM
8.
LOCKOUT TIME
9.
start – HH:MM
10.
TIME 07:00A
11.
start – HH:MM
12.
stop – HH:MM
13.
TIME 07:00P
14.
stop – HH:MM
D-302756
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "no flash" and "all light flash".
Enter the time at which you wish the lockout state to begin (usually at
dawn).
Note: AM and PM are selected by pressing
respectively.
Enter the time at which you wish the lockout state to end (usually in the
evening).
Note: AM and PM are selected by pressing
respectively.
Pressing the
will take you to "
<OK> TO EXIT
or buttons at any stage in the procedure
".
and ,
and ,
61