User Interface Customization; Enabling Trouble Beeps; Enabling Piezo Beeps - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

4.10 User Interface Customization

4.10.1 Enabling Trouble Beeps

Under trouble conditions, the sounder emits a series of 3 short beeps once per minute. Here you determine
whether this special beeping sequence will be active, inactive, or just inactive at night (the range of "night" hours
is defined in the factory but is usually from 8 PM until 7 AM).
The 3 options are: enable beeps (default in USA), off at night (default) and disable beeps.
To Enable Trouble Beeps
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
11:TROUBLE BEEPS
4.
off at night
or
5.
6.
11:TROUBLE BEEPS

4.10.2 Enabling Piezo Beeps

Here you determine whether warning beeps will sound or muted during exit and entry delays. An additional
option is to mute the warning beeps only when the system is armed "HOME".
Options: enable beeps (default), off when home (default in USA) and disable beeps.
Note: When exit beeps are disabled toward the end of a delay, the happy (success) melody will sound.
To Enable Piezo Beeps
1.
DEFINE PANEL
2.
01:ENTRY DELAY 1
or
3.
10:PIEZO BEEPS
4.
D-302756
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Select between "enable beeps", "off at night" and "disable
beeps".
You can now press the
menu in "
DEFINE PANEL
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
or button to program any other
" or press the button to take you to "
or button to program any other
" or press the button to take you to "
<OK>
<OK>
53