Programming; General Guidance; Entering The Installer Menu; Programming User Settings - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

4. PROGRAMMING

4.1 General Guidance

We recommend programming the PowerMaster-10 on the work bench before actual installation. Operating
power may be obtained from the backup battery or from the AC power supply.

4.2 Entering the Installer Menu

The following procedure describes how to enter the Installer Menu.
To Enter the Installer Menu
1.
READY 00:00
2.
INSTALLER MODE
ENTER CODE:
3. CODE
NEW INSTL CODE
or
4.
ZONES DEVICES

4.2.1 Programming User Settings

This mode provides you with a gateway to the user functions through the regular user programming menu.
To Enter the User Settings Menu
1.
USER SETTINGS
2.
Caution! If after having programmed the user codes the system does not recognize your installer code,
this indicates you must have programmed a user code that is identical with your installer code. If so,
access the user menu and change the code that is identical with your installer code. This will re-validate
your installer code.
D-302756
Make sure the system is disarmed and then press the
repeatedly until the PowerMaster-10 display reads "INSTALLER MODE".
Enter your Installer Code.
Press the or
desired setting option, for example, "ZONES/DEVICES".
You can program any other menu or press the
take you to "
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
Refer to the PowerMaster-10 User Guide for detailed procedures
Clicking the or
take you to "
<OK> TO EXIT
button repeatedly until the display reads the
".
buttons at any stage in the procedure will
".
button
or buttons to
11