7.5 Replacing/Relocating Detectors
Whenever maintenance work involves replacement or re-location of detectors, always perform a full diagnostic
test according to section 5.
Remember! A "poor" signal is not acceptable, as stated at the end of the introduction to the test procedure.
7.6 Restoring Factory Defaults
If you want to reset the PowerMaster-10 parameters to the factory default parameters, you should enter the
installer menu and perform the "FACTORY DEFLT" function, as detailed below. To get the relevant parameters
defaults, contact the PowerMaster-10 dealer.
Note: For PowerMaster-10 with 2 installer codes, INSTALLER code and MASTER INSTALLER code, only the
master installer code enables to perform factory default function.
To Reset PowerMaster-10 Parameters to the Factory Default Parameters
1.
FACTORY DEFLT
2.
<OK> to restore
3.
ENTER CODE:
CODE
4.
PLEASE WAIT...
FACTORY DEFLT
7.7 Viewing the Serial Number
The menu "SERIAL NUMBER" allows reading the system serial number and panel ID for support purposes only.
Panel ID is a unique number of the control panel that is used for registering the PowerMaster-10 to IPMP when
using GPRS.
To View the Serial Number
1.
SERIAL NUMBER
2.
0907030000.
3.
JSMivory 0.2.22
4.
Panel ID: 100005
D-302756
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
The screen will now prompt you to enter your installer code.
The factory defaults are now restored.
You can now press the
".
TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
The PowerMaster-10 display will read serial number of the unit.
The PowerMaster-10 display will read the version of the unit.
The PowerMaster-10 display will read the panel ID of the unit.
Pressing the
button at any stage in the procedure will take you
to "
".
SERIAL NUMBER
Pressing the
".
EXIT
or
buttons to take you to "
or
buttons will take you to "
<OK>
<OK> TO
73