Lan Reset Option - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

The following LAN messages are reported:
Message
Unit is ok
Test aborted
Comm. loss
Rcvr Ip missing
Cable unplugged
Check lan config
Rcvr#1 UnReach.
Rcvr#2 UnReach.
Rcvr#1 UnReg.
Rcvr#2 UnReg.
Broadband Module timeout
err.
Invalid result

5.1.7 LAN Reset Option

1.
DIAGNOSTICS
2.
WL DEVICES
or
3.
LAN RESET OPTION
4.
REBOOT
D-302756
See the table below for a complete list of possible LAN messages.
∗ If there are no wireless devices enrolled in the PowerMaster-10
system, the PowerMaster-10 display reads "
** When the
before it is displayed, depending on the severity of the failure.
Pressing the
will take you to "
end of the procedure will take you to the "
Description
PowerLink Broadband Module is functioning correctly.
The diagnostic test is aborted, as follows:
• AC failure – PowerLink Broadband Module is set to OFF mode.
• PowerLink Broadband Module has not completed the power-up procedure. In
this case, the installer should wait a maximum of 30 seconds before re-
testing.
The RS-232 serial interface between the PowerLink Broadband Module and the
PowerMaster-10 failed.
Receivers IP 1 and 2 settings are missing in the PowerMaster-10.
The Ethernet cable is not connected to the PowerLink Broadband Module.
This message appears in any of the following cases:
• Incorrect PowerLink Broadband Module IP has been entered.
• Incorrect subnet mask has been entered.
• Incorrect default gateway has been entered.
• DHCP server failure.
Receiver 1 or 2 is inaccessible, as follows:
• Wrong receiver IP has been entered.
• Receiver failure.
• WAN Network failure.
The PowerMaster-10 unit is not registered to IP receiver 1 or 2.
PowerLink Broadband Module does not respond to test result within 70 sec.
PowerLink Broadband Module responds with a result code that is not recognized
by the PowerMaster-10.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
*
button is pressed the test result takes up to 4 min.
or buttons at any stage in the procedure
" or pressing the
<OK> TO EXIT
".
NO DEVICES
button at the
" menu.
LAN RESET OPTION
69