Table of Contents
Advertisement
you to "
<OK> TO EXIT
procedure will take you to the "
The following GSM/ GPRS messages are reported:
Message
Unit is OK
GSM comm. loss
Pin code fail
GSM net. fail
SIM card fail
GSM not detected
No GPRS service
GPRS conn. fail
Srvr unavailable
IP not defined
APN not defined
SIM card locked
Denied by server
5.1.6 LAN Connection Test
The LAN Connection diagnostic procedure tests Broadband Module communication to the IPMP and reports the diagnostic
result. In case of communication failure, detailed information of the failure is reported.
If the Broadband Module is not registered to the PowerMax10-G2, the menu "LAN CONNECT.TEST" will not be displayed.
1.
Make sure the system is disarmed and then press the
repeatedly until the PowerMax10-G2 display reads "INSTALLER MODE".
2.
When the PowerMax10-G2 display reads [INSTALLER MODE], press
The screen will now prompt you to enter your installer code.
Enter your Installer Code.
3.
The PowerMax10-G2 display will read [NEW INSTL CODE].
4.
When the PowerMax10-G2 display reads [NEW INSTL CODE] press the
or
button repeatedly until the PowerMax10-G2 display will read
[DIAGNOSTICS].
5.
When the PowerMax10-G2 display reads [DIAGNOSTICS], press the
button.
The PowerMax10-G2 display will read [WL DEVICES].∗
6.
When the PowerMax10-G2 display reads [WL DEVICES], press the
button repeatedly until the PowerMax10-G2 display will read [LAN].
7.
When the PowerMax10-G2 display reads [LAN], press the
The PowerMax10-G2 display will read [PLEASE WAIT...] and will then
8.
automatically change to read [UNIT IS OK].
See the table below for a complete list of possible LAN messages.
∗ If there are no wireless devices enrolled in the PowerMax10-G2 system, the
PowerMax10-G2 display reads [
** When the
I
OK
4 min. before it is displayed, depending on the severity of the failure.
Pressing the
you to "
<OK> TO EXIT
procedure will take you to the "
D-302756
" or pressing the
" menu.
LAN
Description
GSM / GPRS is functioning correctly.
The GSM/GPRS module does not communicate with the Panel
Missing or wrong PIN code.
(Only if SIM card PIN code is enabled.)
Unit failed with registration to local GSM network.
SIM not installed or SIM card failure.
GSM auto enroll failed to detect GSM/GPRS module.
The SIM card does not have the GPRS service enabled.
Local GPRS network is not available or, wrong setting to GPRS APN, user and/or password.
IPMP Receiver cannot be reached – Check the Server IP
Server IP #1 and #2 are not configured.
APN is not configured.
After entering a wrong PIN code 3 consecutive times the SIM is locked. To unlock it enter a PUK
number. The PUK number cannot be entered by the PowerMax10-G2.
The IPMP denies the connection request. Check that the Panel is registered to the IPMP Receiver.
NO DEVICES
button is pressed the test result takes between 15 sec. to
or
buttons at any stage in the procedure will take
" or pressing the
LAN RESET OPTION
button at the end of the
button.**
I
OK
].
button at the end of the
" menu.
button
.
I
OK
INSTALLER MODE
ENTER CODE:
NEW INSTL CODE
I
OK
or
PLEASE WAIT...
READY 00:00
I
OK
CODE
or
DIAGNOSTICS
I
OK
WL DEVICES
or
LAN
I
OK
UNIT IS OK
65
Advertisement
Table of Contents
