Reading The Event Log; Erasing And Exiting The Event Log - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

8 READING THE EVENT LOG

Events are stored in the event log. You can access this log and review the events, one by one. If the event log
fills up completely, the oldest event is deleted upon registration of each new event.
The date and time of occurrence are memorized for each event.
When reading the event log, events are shown in chronological order - from the newest to the oldest. Access to the
event log is provided by pressing the
process of the event log is shown below.
8.1 Reading the Event Log
READY 00:00
1.
2.
ENTER CODE:
LIST OF EVENTS
3.
Z13 alarm
09/02/10 3:37 P
4.

8.2 Erasing and Exiting the Event Log

Z13 alarm
09/02/10 3:37 P
5.
CLEAR EVENT LOG
6.
<OFF> to delete
7.
<OK> TO EXIT
8.
READY 00:00
74
button and not through the installer's menu. The reading and erasing
While the system is in the normal operating mode, press the
Enter the current installer code.
The latest event is shown.
The event is displayed in two parts, for example, "Z13 alarm" then
"09/02/10 3:37 P".
Press the button repeatedly to scroll through the list of events.
Pressing the
will take you to "
<OK> TO EXIT
From anywhere within the event log, press the
Note: This is applicable only if the installer code entered.
At this stage in the procedure, pressing the
will take you to "
<OK> TO EXIT
the button will return you to "
The system erases the event log and reverts to the normal operating
mode.
Pressing the
will take you to "
<OK> TO EXIT
or buttons at any stage in the procedure
".
" without erasing the event log. Pressing
CLEAR EVENT LOG
or buttons at any stage in the procedure
".
key.
button.
or buttons
".
D-302756