Diagnostic Test; Testing Devices; Testing All Devices - Visonic POWERMASTER-10 - INSTALLER GUIDE Manual

33.
2nd caller ID#
34.
GPRS UP / DOWN

5 DIAGNOSTIC TEST

This mode allows you to test the functionality of all devices of the system and to receive / review information
regarding the received signal strength. Communication between system components can also be tested and
detailed information is reported.
The wireless signal strength measured and reported (see details in the drawing below).
IMPORTANT! Reliable reception must be assured during the initial testing and also throughout subsequent
system maintenance. A device should not be installed in location where signal strength is "poor". If you
get a "poor" signal strength from a certain device, simply re-locate it and re-test until a "good" or "strong" signal
strength is received. This principle should be followed throughout the diagnostic test procedure.
The diagnostic test process is shown below.

5.1 Testing Devices

This section describes how to test or review a device enrolled to the PowerMaster-10 control panel.
Note:
It is much easier to test the device while holding the device in your hand, close to the control panel.

5.1.1 Testing all Devices

1.
DIAGNOSTICS
2.
WL DEVICES
3.
TEST ALL DEVICES
4.
TESTING Zxx NNN
TEST KEYFOBS NN
or
ACTIVATE NOW Uxx
64
Enter the second IP receiver telephone number.
You can now press the
" menu (see section 4.7.3.8), or press the
ALARM
you to " ".
<OK> TO EXIT
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
(or press the
The PowerMaster-10 system will now perform automatic testing of all
enrolled devices in the following order: repeaters, sirens, detectors,
keypads.
The PowerMaster-10 system will perform automatic testing of keyfobs (if
enrolled) at the end of testing all other devices.
button to take you to the "
button for "TEST ONE DEVICE".)
RPRT CNFRM
button to take
D-302756