Table of Contents
Advertisement
The PowerMax10-G2 display will revert to [PSTN UP / DOWN].
30.
Press the
The PowerMax10-G2 display will read [GPRS UP / DOWN].
31.
Press the
I
OK
The PowerMax10-G2 display will read [My SIM Tel.#]. Here you enter the
PowerMax10-G2 SIM card telephone number. The Monitoring Station dials this
number when it needs to connect to the PowerMax10-G2 for uploading /
downloading data.
32.
When the PowerMax10-G2 display reads [My SIM Tel.#], press the
button.
Enter the SIM card telephone number.
33.
34.
Press the
I
OK
The PowerMax10-G2 display will revert to [My SIM Tel.#].
35.
Press the
The PowerMax10-G2 display will read [1st caller ID#]. Here you determine
st
the 1
IPMP receiver telephone number. When the PowerMax10-G2 responds
to an incoming call from the telephone number defined here, it creates a
connection to the IPMP for uploading / downloading data.
Note: caller ID#1 / ID#2 should be 6 or more digits for wake-up by IPMP to
work.
When the PowerMax10-G2 display reads [1st caller ID#], press the
36.
button..
I
OK
Enter the first IP receiver telephone number.
37.
38.
Press the
I
OK
The PowerMax10-G2 display will revert to [1st caller ID#].
39.
Press the
The PowerMax10-G2 display will read [2nd caller ID#]. Here you determine
nd
the 2
IPMP receiver telephone number. When the PowerMax10-G2 responds
to an incoming call from the telephone number defined here, it creates a
connection to that IPMP for uploading / downloading data.
When the PowerMax10-G2 display reads [2nd caller ID#], press the
40.
button.
I
OK
Enter the second IP receiver telephone number.
41.
42.
Press the
I
OK
The PowerMax10-G2 display will revert to [2nd caller ID#].
43.
Press the
The PowerMax10-G2 display will revert to [GPRS UP / DOWN].
You can now press the
menu (see section 4.6.3.8), or press the
".
EXIT
5 DIAGNOSTIC TEST
This mode allows you to test the functionality of all devices of the system and to receive / review information regarding the
received signal strength. Communication between system components can also be tested and detailed information is
reported.
The wireless signal strength measured and reported (see details in the drawing below).
IMPORTANT! Reliable reception must be assured during the initial testing and also throughout subsequent system
maintenance. A device should not be installed in location where signal strength is "poor" or "bad". If you get a
"poor"/"bad" signal strength from a certain device, simply re-locate it and re-test until a "good" or "strong" signal strength is
received. This principle should be followed throughout the diagnostic test procedure.
D-302756
button.
button.
button twice.
button.
button twice.
button.
button twice.
button.
button to take you to the "
RPRT CNFRM ALARM
button to take you to "
<OK> TO
PSTN UP / DOWN
GPRS UP / DOWN
My SIM Tel.#
I
OK
My SIM Tel.#
1st caller ID#
1st caller ID#
2nd caller ID#
2nd caller ID#
GPRS UP / DOWN
"
I
OK
I
OK
I
OK
I
OK
I
OK
I
OK
I
OK
I
OK
I
OK
I
OK
61
Advertisement
Table of Contents
