Connecting The Programming Console - Omron Sysmac CPM1 Operation Manual

Using a Programming Console

4-2-2 Connecting the Programming Console

Panel Installation
56
Connect the Programming Console's connecting cable to the CPM1's periph-
eral port, as shown below.
The C200H-PRO27-E Programming Console can be installed in a control panel
as shown in the following diagram. (The C200H-ATT01 Mounting Bracket is sold
separately.)
Mounting Bracket
Panel thickness: 1.0 to 3.2 mm
Allow at least 80 mm for the cable connector above the Programming Console.
37
Mounting hole dimensions
(DIN43700 standards)
Two screws
15
At least 80 mm is required.
Either connector may
be used.
About 70 mm is required.
Section 4-2
+1.1
186
–0
+0.8
92
–0