Table of Contents
Advertisement
8/31/22, 1:52 PM
You must go through the QR code-scanning process before each print, even if you are using the same bottle as
your last build. The printer will not begin a print job unless a QR code has been scanned. This is so that the
system can detect certain conditions:
a. If the system detects that the material bottle is empty, it will
ask you to scan another bottle. You will see the message at
the right.
b. If the system detects that the material bottle you scanned
does not match the material in the print-job data, it will ask
you to scan another bottle. You will see the message at the
right.
c. If the system detects that the material bottle you scanned is
past its expiration date, you will see the message at the right
appear for three seconds. You will, however, still be able to
print with the expired material. If you decide NOT to print with
expired material, you may abort the print process by
the power button.
print cancelation.
CAUTION: If you use expired material of any
kind, the integrity of the build might be
compromised. 3D Systems is not responsible
for failed builds or damage to equipment
resulting from expired print-material use.
CAUTION: If you are disposing of the expired
print material, do so according to all local,
state, and federal regulations. Be sure to also
dispose of expired print material that remains
in the print tray and catch tray in the same
manner.
d. If the system detects an invalid QR code, you will see the
message at the right. This could mean the QR code is
damaged or did not scan properly.
infocenter.3dsystems.com/fabpro1000/print/book/export/html/526
Hold down
the power button to con rm
User Guide
Printer Message
pressing
Translation
Cartridge
empty
Please scan
another
Incompatible
material
Verify
material type
Warning
material
expired
Hold button
to continue
Invalid
barcode
Please try
again
60/111
Advertisement
Table of Contents
